Phi-connect is available
April 24, 2011 2 Comments
After some long planning, prototyping and production, the phi-connect system is available for sale. This is a big time saver and headache remover for arduino users. Connect and disconnect your arduino from a project and switch to a different project in seconds. Please check out its own blog page for more details.
Picture:
Here is the list of online stores that sell the kits:
Just got my kit today, Looks nice. One suggestion, Miter the traces on the next Rev on the large board. You had a great idea with this kit, just what I was looking for.
Thank you for your suggestion Daniel! Do you mean laying the traces at angles other than 90 degrees? That will reduce signal loss I bet. Besides, if you get some of these:
http://www.sparkfun.com/products/10007
and these:
http://www.mouser.com/ProductDetail/FCI/68715-472HLF/?qs=sGAEpiMZZMtsLRyDR9nM10e6U9azPmZkNDzvu9FTWAw%3d
You can stack the phi-connect below any shield and use both shields and breadboards!